The Designer’s suggested colors and materials:

14 or 16 gauge round copper wire

20-24 gauge half round or round wire for binding

Hammer and hammering block (or any hard metal surface)

Round nose pliers, nylon jaw pliers, or needle nose pliers

Beads for decoration (optional)

Preparing the Wire: Cut a 4-inch piece of 14 gauge copper wire. Using round nose pliers, create a loop at one end.
Shaping the Wire: Bend the wire into your desired shape, adding loops or curves as preferred.
Hammering the Wire: Place the wire on a hammering block and flatten it with a hammer for a textured look.
Binding the Pieces: Use a 20-24 gauge wire to bind two pieces of hammered wire together at several points.
Finalizing the Design: Adjust the shape and position of the wire pieces. Add additional bindings if necessary.
Decoration (Optional): Decorate your pendant with beads by attaching them using the 24 gauge wire.